Apex Digital K1106 User Manual download pdf (Page 58)

Preparation of an evacuation plan Is of prime importance in fire

prevention. Establish a household emergency evacuation plan in the

event of fire. Refer to the Smoke Detector instructions (or exact

mounting, layout and spacing.

1 - Evaluate possible escape routes from your home.

2 - Select 2 escape routes from each room.

3 - Rooms on the second floor should have a rope ladder Be sure it will

reach the ground.

4 - Draw a sketch of your escape plan so everyone is familiar with it.

5 - Practice your escape plan to assure that everyone knows what to do.

6 - Establish a meeting place outside where your family is to report.

Once you have evacuated, the house do not return to a burning

house.

7 - Advise the local fire authority that you have installed a fire alarm

system.

8 - When the fire alarm signals, LEAVE IMMEDIATELY. Do not stop for

belongings.

9 - If a fire occurs, test the door. If hot, use your alternate route. If the

door is cool, brace your shoulder against it and open it cautiously.

Shut the door to help prevent the fire and smoke from spreading.

Crawl through smoke, holding your breath.

10 - Contact the Fire Department from a neighbor's telephone.

11 - Everyone including neighbors should be familiar with the Fire and

Burglary signals

SYSTEM TESTING

This control unit was manufactured under rigid quality standards.

Maintenance is best performed by your installing company with

trained service personnel.

Installing Company: ____________________________________

Telephone Number: ____________________________________

It is recommended that you test your system once a week using the

following procedure:

* Note: If your system Is monitored by a Central Station then

contact them prior to performing this test.

1-Arm your security system.

2-Activate the system by opening a protected zone (example,

window or door).

3-Confirm that the alarm sounding device (bell or siren) activates.

4-Disarm the system to silence the system and return to normal

status.

In order to test the backup battery the following procedure should

be performed;

1 - Remove the AC transformer from the AC outlet by removing the

restraining screw which secures the transformer to the wall.

(Note: the screw is not present in models sold in Canada).

2 - Observe that status light flashes on the keypad.

3 - Activate your alarm system using steps 1-4 listed above.

4- Replace the AC transformer to the AC outlet and secure using the

retaining screw (Note: The retaining screw is not present in

models sold in Canada).

The National Fire Protection Association publishes a standard for

household fire warning equipment. N.F.P.A. #74. Further Informa-

tion can be obtained by contacting; NEPA Public Affairs Dept.,

Batterymarch Park. Quincy, MA 02269.

If you have any further questions about the operation of your

system, call your installer.

INSTALLATION LAYOUT

Early warning fire detection is best achieved by the installation of fire

detection equipment in the location as follows:

BEDROOM

BEDROOM BEDROOM

BEDROOM

LIVING ROOM

DINING ROOM

KITCHEN

In homes with more than one sleeping

area a smoke detector should be

provided to protect each area.

A smoke detector shall be located between the sleeping area

and the rest of the house.

- Refer to N.F.P.A. #74 Appendix B-1.1 thru B-10.

1 2 ... 53 54 55 56 57 58 59 60

Comments to this Manuals

No comments

Apex Digital K1106 User Manual Page 58

Comments to this Manuals

Related products and manuals for Security access control systems Apex Digital K1106